Simcenter™ software lets you predict the performance of your 3D geometry-based designs.
Using Simcenter™ system simulation solutions, you can evaluate and balance potentially conflicting performance attributes (such as thermal management, operability, drivability or fuel efficiency) from the early development stages until the final performance validation and controls calibration.
In the digital era, it remains crucial to test, validate and optimize real-world designs within the constraints of shorter testing cycles, conflicting performance requirements, growing product complexity and reduced costs.
The measurement microphone sets have been combined so they fulfil our users’ typical measurement needs. Independently of your measurement system and application you should be able to find a set that suits your needs.
The GRAS 43AA is a complete test jig for acoustical measurements on telephone handsets and earphones.
GRAS artificial ears and ear & mouth simulators are designed to enable measurements under well defined acoustical conditions.
DJB offers a service where you can send up to 20 cables for us to inspect free of charge. We will supply a report detailing the health of your cables for you to assess your options.
Charge or IEPE – If you are using a charge accelerometer you will need a charge amplifier. Very few data acquisition systems offer built in charge conditioning so an external box will be required.
Specialist Cable & Assembly for Challenging Applications – Anything IS Possible! DJB provides a bespoke cable assembly service offering a vast range of cables from just 0.8mm diameter, including low noise and armoured solutions whilst offering a wide range of connectors made both in house and off the shelf.
Scan&Paint 2D is a tool to visualize stationary sound fields with an unmatched spatial resolution in full acoustic bandwidth.
The Near Field Acoustic Camera allows localization and real-time analysis of non-stationary noises such as squeaks, rattles and clicks.
Voyager is a portable multi-channel sound analyzer that merges multiple functional units into one device. Data acquisition, signal conditioning and storage are combined into a powerful tablet unit suitable for sound and vibration data recording, NVH testing, acoustic troubleshooting and noise control.
Designing and testing Advanced Driver Assistance Systems (ADAS) can be challenging because of the need to share detailed information about multiple vehicles and targets in real-time.
Direct georeferencing from the air. Accurate position on the ground.
Integrated INS solutions for your product developments
Our driving robots can be installed in almost any vehicle and can deliver repeatable and accurate control of that vehicle in a way that no human driver can do.
LaunchPad is a pilotable platform designed to carry Vulnerable Road User (VRU) targets for ADAS development and testing.
The advanced Vehicle Driving Simulator (aVDS) is a versatile and innovative driving simulator, combining a high-performance motion platform and high specification audio and visual hardware with industry-leading virtual content from rFpro.
Low cost alternative to a fully featured robotic GVT
The Moshon Data EuroNCAP Vehicle Target (EVT) was developed to simulate the rear end of a standard production car and is suitable for RADAR, LiDAR and camera based systems.
The first AEB Validation tool designed for end-of-line-vehicle production facilities.
These vibration exciters (also called shakers) use permanent magnets and are available as portable and stationary systems for simulating ambient vibration conditions.
TIRA Mechanical Engineering manufactures any kind of metal parts by machining. The measuring and Monitoring is ensured by 3D coordinate measurement technology.
Used for calibration of sensors, Ceramic vibration system, Very high utilizable frequency range up to 25 kHz and Special guide system
